IKEA LAGAN Manuel page 6

Normal Installation Steps
1. Anti-Tip Bracket Installation
Instructions
Important Safety Warning
To reduce the risk of tipping of the range, the range
should be secured to the floor by properly installed
anti-tip bracket and screws packed with the range.
Failure to install the anti-tip bracket will allow the range
to tip over if excessive weight is placed on an open
door or if a child climbs upon it. Serious injury might
result from spilled hot liquids or from the range itself.
If range is ever moved to a different location, the
anti-tip brackets must also be moved and installed
with the range.
Instructions are provided for installation in wood or
cement fastened to either the floor or wall. When
installed to the wall, make sure that screws completely
penetrate dry wall and are secured in wood or metal.
When fastening to the floor or wall, be sure that screws
do not penetrate electrical wiring or plumbing.
a. Locate the Bracket Using the Template -
(Bracket may be located on either the left or right
side of the range. Use the information below to
locate the bracket if template is not available).
Mark the floor or wall where left or right side of the
range will be located. If rear of range is against the
wall or no further than 1-1/4" (32 mm) from wall
when installed, you may use the wall or floor mount
method. If molding is installed and does not allow
the bracket to fit flush against the wall, remove
molding or mount bracket to the floor. For wall
mount, locate the bracket by placing the back edge
of the template against the rear wall and the side
edge of template on the mark made referencing the
side of the range. Place bracket on top of template
and mark location of the screw holes in wall. If
rear of range is further than 1-1/4" (32 mm) from
the wall when installed, attach bracket to the floor.
For floor mount, locate the bracket by placing back
edge of the template where the rear of the range
will be located. Mark the location of the screw
holes, shown in the template.
6
b. Drill Pilot Holes and Fasten Bracket - Drill a
1/8" (3 mm) pilot hole where screws are to be
located. If bracket is to be mounted to the wall,
drill pilot hole at an approximate 20° downward
angle. If bracket is to be mounted to masonry
or ceramic floors, drill a 5/32" (4 mm) pilot hole
1-3/4" (44 mm) deep. The screws provided may
be used in wood or concrete material.
5/16" (8 mm) nut-driver or flat head screwdriver
to secure the bracket in place.
c. Level and Position Range - Level range by
adjusting the (4) leveling legs with a wrench.
Note: Aminimum clearance of 1/8" (3 mm) is
required between the bottom of the range and the
leveling leg to allow room for the bracket. Use
a spirit level to check your adjustments. Slide
range back into position. Visually check that rear
leveling leg is inserted into and fully secured by
the Anti-Tip Bracket by removing lower panel or
storage drawer. For models with a warmer drawer
or broiler compartment, grasp the top rear edge of
the range and carefully attempt to tilt it forward.
(17 mm)
Use a
(32 mm)
(32 mm)
AA-2195044-2