Hilti SID 14-A Mode D'emploi Original page 14

2. Pull the chuck ring forward and hold it in this position.
3. Pull the accessory tool out of the chuck.
4. Release the chuck ring.
5.5 Fitting an accessory tool
SIW 14­A
SIW 22­A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Bring the notch in the accessory tool into alignment with the ball on the square drive.
4. Push the accessory tool onto the square drive until it engages.
5.6 Removing the accessory tool
SIW 14­A
SIW 22­A
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Pull the accessory tool off the square drive.
5.7 Setting the torque 8
▶ Press the torque selector button as many times as necessary until the desired torque setting is indicated
to the left of the button.
SID 14­A
SID 22­A
Model SID ... → page 6
SIW 14­A
SIW 22­A
Model SIW ... → page 6
5.8 Setting forward or reverse rotation
Note
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
5.9 Screwdriving
WARNING
Risk of injury and damage. Screws/bolts or the workpiece may be damaged by excessively high
torque; this may also lead to serious injury.
▶ Ensure that the fastener and attachment will withstand the level of torque generated by the tool.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Use the torque selector button to set the desired torque. → page 8
8 English
Printed: 06.06.2017 | Doc-Nr: PUB / 5155097 / 000 / 03
6
7
9