Hilti SID 14-A Mode D'emploi Original page 13

5 Operation
5.1 Inserting the battery
WARNING
Risk of injury! Inadvertent starting of the impact screwdriver.
▶ Before fitting the battery, check that the cordless impact screwdriver is switched off and that the
forward/reverse switch is in the middle position (i.e. safety lock engaged).
WARNING
Electrical hazards! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts in the
impact screwdriver are free from foreign objects.
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the battery is
securely seated in the power tool.
▶ Fit the battery and make sure that it is heard to engage.
5.2 Fitting the belt hook (optional)
WARNING
Risk of injury! Hazard presented by a falling power tool.
▶ A falling power tool may present a risk of injury to yourself and others. Check that the belt hook is
fitted securely before beginning work.
Note
The belt hook allows the power tool to be attached to a belt worn by the operator. The belt hook can
be fitted to allow attachment on the left or right side of the body.
▶ Fit the belt hook.
5.3 Fitting an accessory tool
SID 14­A
SID 22­A
1. Check that the connection end of the accessory tool is clean.
Result
The connection end is dirty.
▶ Clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
5.4 Removing the accessory tool
SID 14­A
SID 22­A
CAUTION
Risk of injury. The accessory tool may be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
Printed: 06.06.2017 | Doc-Nr: PUB / 5155097 / 000 / 03
2
3
4
5
English 7