Spypoint FL-8 Manuel D'utilisation page 5

8 9
Note: When the photo resolution is set to "L", the video
resolution is automatically set to 320 x 240 and if the photo
resolution is set to "H", the video resolution is automatically
set to 640 x 480.
MODE
PHOTO
Allows you to take pictures. When the PHOTO mode is selected, the
test light in front of the camera (see below) will fl ash for 60 seconds
to allow the user to leave the area without being photographed.
Test light
MS-1 activated
VIDEO
Allows you to take videos. When the VIDEO mode is selected, the
test light in front of the camera (see above) will fl ash for 60 seconds
to allow the user to leave the area without being recorded.
Note: Video available at night with the IR unit only.
SET/TEST
.
Allows the user to test the detection system of the camera When
the SET/TEST mode is selected, no picture or video is recorded.
IRB-W activated
Walk perpendicularly in front of the camera. When the camera
detects movement, the light blinks to indicate that normally, a
photo or video would be recorded. If the system does not detect
the movement, increase the distance detection using the wheel
DISTANCE or realign the system differently. When you understand
how the device responds to detections, you can better adjust the
direction or the height of the installation.
RC-1 activated