Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
START-S6XL BLOCK
4.2
Connection of the network tension
1
2
3
4.3
Motor connection
Be particularly careful in not mistaking the Opening pole with the
Closing pole.
In case you have doubts about the correct connections, put ma-
nually, if possible, the gate in the middle position of the course. Be
ready to block the system with the STOP command.
4.4
Connection of the SIGNAL LIGHT
Signal light complete with
intermittent electronic card
4
5
6
4.5
Connection of a 24Vdc light with an open and moving gate
29
30
31
32
_
+
230 Vac. The line of power supply towards the control board must
always be protected with an electromagnetic switch or with a 5a fuse
couple.
A differential switch is recommended but not indispensable if it is alre-
ady present in the installation.
230 Vac
26
27
4
intermittent electronic card
4
5
6
If you are expecting to use the test on the
photocells or for a 24V light,
you can't use this connection.
If you are expecting to use the test on the
photocells or for a signal light, you can't use
this connection.
Keep pressed the button TEMPI for a fixed or
a flashing light until the LED-L1 starts flash-
ing when the gate is closing.
-8-
Technical manual
5
7
8
9
6
MOTOR 1
Signal light without
26
27
10
11
MOTOR 2
Publicité
Table des Matières
