Safety Precautions - EB TECHNOLOGY START-S6XL BLOCK Notice D'emploi

START-S6XL BLOCK
1 Introduction
1.1

Safety precautions

Using the unit improperly and performing repairs or modifications personally will void the warranty. The producer
declines any responsibility for damages due to inappropriate use of the product and due to any use other than
the use the product was designed for. The producer declines any responsibility for consequential damages
except civil liability for the products.
1.2 Symbols and warning
Generic Danger
This is a warning and if it is not
respec it can provoque material
damage!
Equipement under electrical
tension
Installation only from qualified
installers.
1.3 Security System
It is important to establish the "MACHINE" risks and the requirements of the final user. In the photo the final
user will fix the number of accessories to be installed. In the scheme the couple of the photo-beams A OPEN
it has no effect while it inverts completely after closing. "FOTO A2" is the serial connection of the foto A or ALT
connection. Check the synchronisation of the photo-beams which avoid interferences.
Swing gates
We recommend to install a STOP command for the immediatelly stop of the gate. The switch is a normally
closed contact as shown in the par. 4.8
Read carefully the manual
Read carefully the manual before
installing
-3-
Technical manual
Sliding gates
FOTO A
FOTO A2