Installation Instruction - GE GLDT690JWW Instructions D'installation

STEP 2 – ADJUST LEVELING LEGS
• Move the dishwasher close to the installation location
and lay it on its back.
Adjust to
Adjust to
Installation
Installation
Height
Height
• Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base, 1/4"
less than installation height.
STEP 3 – REMOVE TOEKICK
• Remove the 2 toekick screws. Lift off the 2 piece toekick.
NOTE: You may have to open the dishwasher door to
access the toekick screws.
CAUTION:
Dishwasher may tip forward if the door is opened.
PRECAUCIÓN:
El lavavajillas se puede caer hacia delante si la puerta es
abierta.

Installation Instruction

2-Screws
STEP 4 – INSTALL POWER CORD
Skip this step if dishwasher will be direct wired.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
Recommended power cord length is 54" min. and 64" max.
A
Remove
junction box
cover
E
Use UL Listed
Replace
wire nuts
junction box
cover
Connect incoming power cord white (or ribbed)
to dishwasher white. Black (or smooth) to black. Ground
to dishwasher green wire. Use UL Listed wire nuts of
appropriate size. Replace junction box cover. Be sure wires
are not pinched under the cover.
STEP 5 – INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape on both threads.
• Install a 90° elbow onto the water valve.
°
90
Elbow
• Do not over tighten 90° elbow, water valve bracket could
bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.
6
B
Check that white, black and
green dishwasher wires are threaded
through hole in back
White
Ground
D
C
Insert power
cord wires through
strain relief
and tighten
Fill
Hose
Water
Valve
Bracket
Thread
Seal Tape
Black