GE GLDT690JWW Instructions D'installation page 7

STEP 6 – POSITION WATER LINE AND
HOUSE WIRING
• Position water supply line and house wiring on the floor of
the opening to avoid interference with base of dishwasher
and components under dishwasher.
Water
Line
STEP 7 – INSERT DRAIN HOSE THROUGH
CABINET
• Upright the dishwasher and position in front of the
opening. Insert drain hose into cabinet wall hole. If a
power cord is used, guide the end through a separate
hole.
Insulation
Blanket
TIP: Position water line and house wiring on the floor
to avoid interference with base of dishwasher.
Installation Instructions
4"
6"
House
Wiring
Maximum
Drain Hose
Length 10'
Water
Line
Drain
Hose
House
Wiring
Power Cord
(If Used)
STEP 8 – SLIDE DISHWASHER PARTIALLY
INTO CABINET
IMPORTANT
with knees. Damage will occur.
• Slide dishwasher into the opening a few inches at a time.
Do not push against
front door panel with
knee. Damage to the
door panel will occur.
• As you proceed, pull the drain hose through the opening
under the sink. Stop pushing when the dishwasher is a
few inches forward of adjacent cabinetry.
• Make sure drain hose is not kinked under the dishwasher
and there is no interference with the water line and
wiring or any other component.
7
–
Do not push against front panel