Installation; Preparation - HellermannTyton SpotClip-Plate Manuel D'utilisation

5 Installation

WARNING
Possible lethal danger due to fire!
The use of unsuitable insulating material and damp-proof
foils or vapour barriers can cause a lethal fire.
f Comply with the local regulation on fire prevention and
the installation instructions from the light manufacturer.
f Comply with the applicable stipulations and standards for
insulating materials and damp-proof foils or vapour
barriers.
f Do not use flammable insulating materials.
f Only use flame-resistant damp-proof foils or vapour
barriers.
f Do not use insulating materials made of natural
substances such as wood, hemp or straw.
f Do not use any loose insulating materials or blown-in
insulation.
5 .1 Overview
SpotClip-Plate.
SpotClip-Caps.
SpotClip-Caps in application with standard IRL tube.

5 .2 Preparation

Proceed as follows:
1 Select the required diameter of the light to be installed.
2 Cut the eight stays using a handsaw so that the excess
piece can be removed.
Sawing the SpotClip-Plate to size.
; The product is properly prepared.
Operating instructions • SpotClip-Plate • 09-2017 • 009-50104
Installation
5