Marmitek HOMEGUARD MS8000 Mode D'emploi page 4

d. The sensor should not be placed above or near
heating elements or in front of air-conditioners.
e. Do not mount the sensor on a metal surface or
next to electrical equipment such as TV sets or
computers.
Caution:
a. Radio equipment (e.g. wireless headphones or
loudspeakers) working on a frequency band of
433MHz will not create a false alarm, however,
these devices will limit the RF range of the
remote control considerably.
b. Pets, e.g. dogs or cats, may trigger the alarm,
and should therefore not be kept in the same
room as where the activated sensor is mounted.
5. PIN CODE SETTING:
Your HomeGuard can be operated and programmed
by using a so-called PIN code (Personal Identification
Number). The factory default code is: [0000]. To
avoid unauthorised use, enter your own PIN code.
Note: Choose a code you will easily remember,
since the HomeGuard will recognise this code only
for further operation.
1. Enter your current PIN (Personal Identification
Number). If you have never changed this code
4
All manuals and user guides at all-guides.com
before, the factory default code is [0000]. You will
hear three high tones and one low tone as confir-
mation. The green indicator will start flashing.
2. Press 5 on the keyboard of the HomeGuard: One
low tone is given for confirmation.
3. Enter a new 4-digit PIN code: You will get three
high tones and one low tone as confirmation
and the indicator stops flashing.
6. PROGRAMMING OF
TELEPHONE NUMBERS.
You may select up to three telephone numbers to
be contacted if the alarm is triggered. These num-
bers may include mobile (GSM) numbers, however
you are not allowed to use national emergency
numbers from e.g. police, paramedical, etc.
The numbers you chose should be have well
informed people, instructed by you and able to help
in case of an alarm (e.g. neighbours, friends, rela-
tives or your own mobile).
To enter telephone numbers:
1. Enter your PIN (Personal Identification Number).
Factory default is [0000]: You will hear three
high tones and one low tone as confirmation.
The green indicator starts flashing.
2. Press 2 on the keyboard of the HomeGuard: One
low tone is given for confirmation.
3. Press the [ * ] button: One high tone is given for
confirmation.
4. Enter the first telephone number you selected
(max. 16 digits). If a dialling pause is required
(e.g. with a certain type of PABX between 0 and
the number you want to dialled in order to
obtain an outside line) press another [ * ] for a
one second pause. One high tone is given for
confirmation of each number entered.
5. Press #: One high tone is given for confirmation.
6. Press 1 to place the telephone number you just
entered in memory location 1. One short low tone
is given and the green indicator stops flashing.
Repeat this procedure with the two other selected
telephone numbers by pressing 2 and 3 for placing
these in memory positions 2 and 3 respectively.
Note: All three numbers should be entered. You
may enter the same number more than once.
Call Identification:
If you select telephone numbers of people who's number
MARMITEK