Triax TVC 05 Guide De Mise En Service page 3

QUAD and QUATRO Optical Virtual Converter/Receiver Installation Guide
Fig.3
If using a splice, coil the fibre so that the splice tube aligns to the centre of the groove on
the side of the base plate (Fig.4) tape down the coiled fibre on to the converter. Push the
splice tube into the slot on the side of the base then coil the fibre around the base ensu-
ring it is inserted in the slot, Covering the splice tube with at least one layer of protected
fibre as shown in (Fig.5)
Fig.4 Fig.5
Use a conventional signal level meter or spectrum analyser to check the output signals
for both satellite and terrestrial on each output, both types (QUAD or QUATRO) conver-
ters can be powered from the meter.
Connect up the required coaxial cables to each of the outputs. On the QUAD version if
terrestrial as well as satellite is required connection should be made via a standard tri-
plex/quadplex wall plate as the terrestrial is diplexed onto all four satellite outputs.
For the QUATRO version the outputs should be connected directly into a multiswitch.
If only terrestrial is to be used then an external power supply (available separately)
should be attached to power the converter unit.
With all cables connected, place the cover over the unit (making sure not to trap any fib-
re) then slide up to click into place.
Once all set top boxes are connected and powered up, check for correct operation.
F-connectors with polarities + TER (QUATRO) / universal outputs (QUAD)
3
English
TVC 05, 307627 / TVQ 05, 307629