Triax TVC 05 Guide De Mise En Service page 2

QUAD and QUATRO Optical Virtual Converter/Receiver Installation Guide
Copyright ©
Triax A/S
©
English
Introduction
The purpose of this guide is to enable the successful installation of the Triax TVC 05 QUAD and
TVQ 05 QUATRO products.
This guide assumes that;

The converter is connected to a suitable Triax Passive Optical Network (PON), providing a
minimum optical signal levels of -12dBm at the connection point of the converter.

The converter has been installed in a dry environment and mounted with suitable fixings.

The installation is carried out by a competent person.

All ferrule end faces of the FC/PC optical connectors are cleaned prior to making a connec-
tion using a suitable fibre optic cleaning kit.
Cables and Connections
Cables used should be industry approved coaxial cable and should be terminated using an F type
connector. Fibre optic cable should be Triax approved single mode with FC/PC connections.
Mounting
Ensure the black back plate is mounted on a suitable wall or flat surface, with enough room to
allow the cover to slide on and off, sufficient space should be left for the cables to exit the lower
part of unit. Click the converter unit into place as shown in the diagram (Fig.1 and Fig.2)
Fig.1
Next connect the fibre connector into the optical input of the converter (ensuring the end is clea-
ned first) as per the following diagram.
If using pre-terminated fibre, coil the fibre around the base in the slot provided (Fig 3), up to 1.2m
of Triax 3mm armoured fibre (GI-3.0) can be coiled in this way.
Fig.2
2
TVC 05, 307627 / TVQ 05, 307629