Blower Mode Assembly; Vacuum Mode Assembly; Operation - Black & Decker BV3100 Manuel D'instructions

blower mode assembly

noTe: Ensure the blower is switched off and disconnected from
the power supply before attaching or removing the blower tubes.
The tube assembly must be assembled to the housing before use.
Tube assembly (figure a)
• To attach the two piece blower tubes to the blower, line up the tube
with the blower housing as shown in figure a. Push the tube into the
blower housing until the lock lever engages the lock hole in the tube.
• To remove the tube depress the lock button and slide the tube off
the housing neck.
A

VaCuum mode assembly

VaCuum Tube assembly (figures b, C, d)
noTe: Ensure the vacuum is switched
off and disconnected from the power
supply before attaching or removing the
vacuum tube. The vacuum tube and
collection bag must be assembled to
the housing before use. The vacuum
tubes must be assembled together
before use.
• Align the notches and the tabs on the
two tube pieces. (figure b)
• Push the lower tube firmly into the
B
B1
upper tube, until the tabs click into place. (Never operate apart).
CauTion:
CUT HAZARD. Ensure the tube assembly is securely
seated and latched into position.
• Unlatch the fan cover from the bottom of the vacuum housing by pressing
the release tab (located near the front of the vacuum housing) and pulling
the cover open like a lid (figure b1).
noTe: This interlock will disconnect the electric circuit automatically
and the unit will not operate.
• Attach the vacuum tube assembly to the
fan inlet on the vacuum housing (figure
C), insert the vacuum tube support tab
into the assembly slot (figure C1) on the
blower housing.
• Push the lock button to lock the vacuum
tube in place.
CauTion:
CUT HAZARD. `Ensure
the vacuum tube assembly is securely
seated and latched into position.
noTe: This interlock will connect the electric circuit automatically and
the unit will operate.
ColleCTion bag assembly (figure d)
noTe: Ensure the vacuum is switched
off and disconnected from the power
supply before attaching or removing the
collection bag.
• Remove blower tube if attached.
• Push the collection bag on to the blower
housing until the lock lever engages the
lock hole as shown in figure d.
always wear safeTy glasses. wear a filTer mask if
THe operaTion is dusTy. use of rubber gloVes and
subsTanTial fooTwear is reCommended wHen working
ouTdoors. for HouseHold use only.
warning:
CuT Hazard. When turning the tool off for tube
installation or any other reason, wait 10 seconds for the fan to stop
5
C
C1
D

operaTion