Blower Mode Assembly; Vacuum Mode Assembly - Black & Decker BV3600 Manuel D'instructions

BLOWER MODE ASSEMBLY

NOTE: Ensure the blower is switched off and disconnected from the
power supply before attaching or removing the blower tubes. The
tube assembly must be assembled to the housing before use.
TUBE ASSEMBLY (FIGURES A, B, C)
• Ensure grill cover is attached to the power head. If not, attach
cover as shown in the inset of figure 1. NOTE: Unit will not operate
in blow mode without grill cover in place. Align the upper and lower
tubes as shown in figure A.
• Push the lower tube firmly into the upper tube, until the tubes click
into place.
• Blow tubes must be assembled to the
power head before use.
• Never operate without both lower and
upper tubes assembled.
• In the interest of safety, it is not
intended for the tubes to be
separated once assembled.
• Push the tube assembly onto the
power head until it is in the fully
locked position (figure B).
• Use the air concentrator attachment
to target air flow to a tighter area. Add
the attachment to the assembly as
shown in figure C. Push on until hole
in tab engages raised post on tube.
A
B
C
5

VACUUM MODE ASSEMBLY

VACUUM TUBE ASSEMBLY (FIGURES D, E, F)
NOTE: Ensure the vacuum is switched off
and disconnected from the power supply
before attaching or removing the vacuum
tube. The vacuum tube and collection
bag must be assembled to the housing
before use. The vacuum tubes must be
assembled together before use.
CAUTION:
CUT HAZARD. Ensure
the tube assembly is securely seated and
latched into position.
NOTE: This interlock will connect the
electric circuit automatically and the unit
will operate.
• Vacuum tubes must be assembled
together before use.
• Align the notches and the triangles on
upper and lower tubes. (figure D)
• Push the lower tube firmly into the
upper tube, until the triangles click
into place. (Never operate apart).
• In the interest of safety, it is not
intended for the tubes to be
separated once assembled.
• Remove the fan cover from the bottom
of the power head by pressing the
spring loaded release button (located
on the back of the power head) and
pulling the cover off (figure E).
• Attach the vacuum tube assembly
to the power head (figure F) by
locating the assembly as indicated
by arrow, then pivot about this point
until the locking/release catch is fully
engaged.
D
D E
F