7 seconds before you try to restart the product to
make sure that the switch resets.
To use a nozzle
•
Use the standard nozzle when precision and high air
stream concentration is necessary. (Fig. 25)
•
Use the high velocity nozzle when a wider airstream
and large air velocity is necessary. (Fig. 26)
To adjust the blower nozzle
1. Twist the nozzle to the left to disengage the bayonet
mount.
2. Move the nozzle to applicable position.
3. Twist the nozzle to the right until you feel a click.
To vacuum
Before you vacuum, put on the necessary safety
equipment.
WARNING: Make sure that the collection
bag is not damaged and that the zipper is
closed before use. Do not use a bag that is
damaged. This prevents injury caused by
flying debris. Left hand operation increases
the risk. Do not let your body touch the
exhaust outlet area.
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
Maintenance schedule
Make sure that you obey the maintenance schedule.
The intervals are calculated from daily use of the
product. The intervals are different if you do not use the
product each day. Only do the maintenance work that is
found in this manual. Speak to an approved service
center about other maintenance work not found in this
manual.
Daily maintenance
•
Clean the external surfaces.
•
Examine the speed control and the throttle trigger
function. Replace damaged parts.
•
Examine the stop switch. If it is necessary, replace it.
•
Examine the idle speed.
•
Clean the air filter. If it is necessary, replace it.
•
Make sure that the inlet cover can be locked in
closed position. Make sure that the impeller is clean.
•
Tighten all nuts and screws.
•
Make sure that the housings are free of cracks.
•
Make sure that the collection bag is not damaged
and that the zipper works. Replace the bag if
necessary.
12
•
During operation of the blower the collection bag
must be held by the shoulder strap. The strap must
be worn on the top of the shoulder.
•
Start the blower. Obey the instructions in the start
and stop section
Safety instructions for operation of the blower on
page 8 .
To empty the collection bag
1. Stop the product.
2. Open the zipper on the side.
3. Empty the collection bag.
4. Close the zipper.
Maintenance
Weekly maintenance
•
Examine the condition of the starter device, the
starter rope and the tension spring. Replace all
damaged parts.
•
Examine the condition of the air intake at the starter
device. Remove debris if the air intake is clogged.
•
Clean the external side of the spark plug. Remove it
and examine the electrode gap. Adjust the distance
to 6 mm (0.024 in) or replace the spark plug.
•
Clean the blades on the impeller.
•
Clean the spark-arresting screen and replace it if
necessary (not on mufflers with a catalytic
converter).
•
Clean the carburetor area.
•
Clean the air filter.
Monthly maintenance
•
Examine the starter rope handle and the starter
rope.
•
Clean the fuel tank.
•
Clean the carburetor and the area around it.
•
Clean the blades on the impeller.
•
Examine the fuel lines for cracks or other damage.
Change if necessary
•
Change the fuel filter in the fuel tank.
•
Examine all cables and connections.
•
Replace the spark plug.
WARNING: Do not start the blower if the
inlet cover is open or damaged (except if the
vacuum tube is fitted).
# . Read the safety instructions
WARNING: Always examine the collection
bag. Make sure that it is not damaged and
that the zipper is closed before use. Do not
use a damaged bag. There is a risk of injury
because of flying debris. Be careful if left
hand operation is applied. Do not touch the
exhaust outlet area.
214 - 007 - 16.12.2019