Technical Data - Husqvarna 125B Manuel D'utilisation

• Change the air filter.
Yearly maintenance
• Examine the spark plug.
• Clean the external surface of the carburetor and its
adjacent areas.
• Clean the cooling system.
• Examine the spark arrester screen.
• Examine the fuel filter.
• Examine the fuel hose for damage.
• Examine all cables and connections.
50 hours maintenance
• Have an approved service center repair or replace
the muffler.
To adjust the idle speed
• Make sure that the air filter is clean and the air filter
cover is attached before you adjust the idle speed.
• Adjust the idle speed with the idle adjustment screw
T which is identified with "T" mark.
• The idle speed is correct when the engine operates
smoothly in all positions.
(Fig. 27)
1. Turn the idle adjustment screw clockwise for higher
speed.
2. Turn the idle adjustment screw counterclockwise for
lower speed.
To do maintenance on the spark
arrester screen
Use a wire brush to clean the spark arrester screen.
To clean the cooling system
(Fig. 28)
Engine Specifications
Cylinder displacement
Electrode gap
Fuel tank volume
Idle speed
Maximum power speed
Power output
214 - 007 - 16.12.2019
Clean the parts of the cooling system with a brush.
To examine the spark plug
• Examine the spark plug if the engine is low on
power, is not easy to start or does not operate
correctly at idle speed.
• To decrease the risk of unwanted material on the
spark plug electrodes, obey these instructions:
a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
• If the spark plug is dirty, clean it and make sure that
the electrode gap is correct. See
• Replace the spark plug, if necessary.
To do the maintenance to the air filter
To clean the air filter
1. Remove the air filter cover and remove the air filter.
(Fig. 30)
2. Clean the air filter with warm soap water. Make sure
that the air filter is dry before you install it.
3. Replace the air filter if it is too dirty to fully clean it.
Always replace a damaged air filter.
4. If your product has a foam air filter, apply air filter oil.
Only apply air filter oil to a foam filter. Do not apply
oil to a felt filter.

Technical data

unit
(125B28HV)
3
cm 28
mm 0.6
3
cm 500
-1
min 2800 - 3200
-1
min 8000
kW 0.8
CAUTION: Always use the recommended
spark plug type. Incorrect spark plug type
can cause damage to the product.
125B 125BX
(125B28HV)
28
0.6
500
2800 - 3200
8000
0.8
# . (Fig. 29)
125BVX
(125B28HV)
28
0.6
500
2800 - 3200
8000
0.8
13