Charging Battery - MeisterCraft MAS 180-22D Manuel D'utilisation

MC-5451330-Bedien-0909.qxd
• The connection cord cannot be
replaced. In case of damage, dispose
of the device in the correct manner. In
case of damage, dispose of the
device in the correct manner.
Safety notes for battery/charger
• Keep the charger away from rain or
damp. Water entering into the
charger will increase the risk of an
electrical shock.
• Keep the charger clean.
Contamination will increase the risk of
an electrical shock.
• Check the charger, cable and plug
each time you use the unit. Do not
use the charger if you find any
damages. Never open the charger
up yourself, have it repaired by a
qualified specialist only and with
original replacement parts. A
damaged charger, cable or plug will
increase the risk of an electrical
shock.
• Never operate the charger on a
surface that will burn easily (for
example, paper, textiles etc) or in a
flammable environment. There is a
risk of fire occurring as a result of the
heat generated during the charging
process.
• Do not open the battery. There is a
risk of short-circuiting.
• In the event of damages and
incorrect use, vapours may come
out of the battery. Ensure plenty of
fresh air and, if you have any
symptoms, consult a doctor. These
vapours may irritate the respiratory
system.
62
11.09.2009 16:34 Uhr
7 – Charging battery
may only be charged using the
XR-DC 1000 mains adapter unit. The
mains adapter unit may only be
operated with a power supply that
has an alternating current of
200-240 V and a frequency of 50 Hz.
The use of any other mains adapter
units or the use of the XR-DC 1000
with another type of power supply
may lead to personal and property
damage.
Charging process (Fig. 3)
The rechargeable battery is not fully
charged on leaving the factory. Charge
the rechargeable battery before first use.
Withdraw rechargeable battery (5) from
the storage battery drill screwdriver
(Fig. 2). Connect charging unit (6) to the
power supply.
Put the rechargeable battery into the
charging bay (8). The charging progress
is displayed by the LED control lights of
the control panel (7):
• If no LED is lit: There is no battery in
• The red LED is lit: The battery is in
• The green LED is lit, the red LED has
• The yellow LED is lit: A problem/fault
Seite 62
This MeisterCraft MAS 180-22D
battery-powered screwdriver
the charging bay.
the charging bay, the recharging
process has been started.
gone out: The charging process has
been completed. The battery is
charged. The charging process
should take about 60 minutes.
has occurred. If this happens, wait a