Eurosystems M250 EVO Mode D'emploi page 15

the lever on handlebar as follows: insert the wire (3) and the register (4) in the hole cut in the prong (5); insert the sheath terminal (1) into the hole (2).
MOWING BAR ASSEMBLING (Fig. 4)
accessories. The engine should be switched off and the machine horizontal: insert halfway the cutter bar pin (1) into its seating (2). Install the belt (3) on the
pulley by moving the guide pin all the way to the end of the motion. Attach the springs (4) to the their hooks (5) into the holes (11). Assemble the hood (6) using
its centering pin (7). Tighten the nut (8) and its washer on the hood.
DRIVE BELT BAR ACTION ADJUSTMENT (Fig. 5)
you have to use the register (2) so that the mowing bar could start working only when the control drive lever has already moved more than halfway its
travel.
HOW TO OPERATE THE DRIVE OF THE CUTTING BLADE (Fig. 5):
the tool insert (4).
BELT-STRETCHER CONTROL ADJUSTMENT (Fig. 6)
moved more than halfway its travel. When the lever is pulled to full extent (working position) the belt-stretcher load spring (2) should extend between 6-8 mm.
to obtain the am conditions you have to act on the nut (1) set close near the belt-stretcher control.
HANDLEBAR HEIGHT ADJUSTMENT (Fig. 7)
Please act as follows: slacken off screws (1) bring the guide block in the desired position, close the screws (1). Repeat the same operation on both guide blocks.
CUTTING BLADE REGULATION (Fig. 8)
using means of screws (1) and their locknut. Every time in order to control the regulation you have first to disassemble the hood then slowly make the pulley to
turn (2) and then verify if the blades are easily moving.
HANDLEBAR SIDE ADJUSTMENT (Fig. 14)
to work, to regulate the handlebar according to operator needs in order to make the machine easier to handle in every position. The side handlebar adjustment
can be obtained on 3 different positions: please follow the steps: turn the lever anticlockwise (8) to detatch the clamping regulate the handle in the needed
position. Fix the handlebar again turning the lever (8) clockwise and check that teeth/gears should be fully conncted.
MAINTENANCE
Air filter: It has to be regularly cleaned following engine instructions.
GEARBOX (Fig. 9)
Use SAE 80. Check the oil level before engine starting. The oil level can be controlled positioning the machine as in the drawing
and removing the cap on gearbox side. Please change/check the oil level every 60 working hours.
ATTACHMENT COUPLE (Fig. 10)
The mower is equipped with a quick coupling to allow an easy connection of the mowing bar and
To increase belt tensioning of the bar action between machine and its attachement,
Warning! - Tyres should start rotating only when the drive control lever has
If you need to mow on rough soil, it is necessary to regulate the height of the mowing bar.
After the blade substitution or after some working hours the knife-guide should be regulated by
The mower handlebar can be both side and height adjusted. It would be better before starting
After use, clean and grease the cutting bar seating with the oil-feeder (1).
disconnect the safety lever (3), then push down the lever for
11