Quick Measure Speaker Position Helper - Paradigm PERSONA SUB Guide De L'utilisateur

ANTHEM ® ROOM CORRECTION (ARC

QUICK MEASURE SPEAKER POSITION HELPER

If subwoofer positioning is flexible, you can try using Quick
Measure before running ARC. (Alternatively you can start
with a full measurement and then see whether it might be
necessary to re-position your subwoofer.) To use Quick
Measure:
• Click the Quick Measure icon.
• Click Connect and then select the device you want
to measure.
• Once connected, click Start to enable the sweep tone
for the speaker that you are positioning.
• After a few sweeps the graph will show a live update of
the uncorrected measurement. It will keep running until
you turn it off.
• You may now move your subwoofer around the room
and watch for when the response graph
is flattest.
• Leave your subwoofer where the graph is flattest,
particularly in the bass frequencies, click Stop and close
the Quick Measure window, and then run ARC normally.
13
™ )
(continued)
NOTE: If you are using multiple subwoofers, you must
repeat the process for each one.
BASIC ARC MEASUREMENT
1. With your microphone set in Position One, the "main
measurement position," use the USB to connect both
the microphone and the ARC-ready equipment being
measured to a USB input on your computer.
2. Before starting to measure, set the subwoofer's GAIN
control to the center/detent position; set CUT-OFF
FREQUENCY to BYPASS, and set PHASE CONTROL
to "0". After running ARC, these controls can be
adjusted as necessary as you complete the setup of
your system. (Refer to section on Fine Tuning)
3. Run ARC by selecting it from the Start Menu. The
program will guide you through the measurement
steps. At the end of the process, ARC will
automatically load the room correction data to your
equipment. The process takes about 10 minutes
depending on the number of measurements.