Cable Connections - Conceptronic Grab'n'GO CHD2FWU Guide De Démarrage Rapide

ENGLISH
3. Hardware Installation CHD2FWU
3.1 Assembling the CHD2FWU (When no hard disk is installed yet)
If you bought the CHD2FWU with a hard disk pre-installed, you can skip this step and
continue to step 3.2
a. Remove the 2 screws at the back of the CHD2FWU.
b. Gently slide the hard disk tray out of the back of the housing.
c. Connect the 2,5" hard disk gently to the connector. Make sure the connector is
connected correctly to the hard disk.
d. Slide back the tray in the housing.
e. Fasten the 2 screws to secure the tray in the housing.

3.2 Cable connections

a. Connect the USB or FireWire cable to the CHD2FWU and to a free USB or FireWire
port on your computer. The device will automatically power on.
Windows 2000 & XP Automatically will recognize the hard disk. No driver installation is
required to operate the CHD2FWU.
Note: Some computers do not supply enough power on
the USB or FireWire port, which results in a not-
booting hard disk. In that situation, use the
supplied Power-to-USB cable to add extra power
to the CHD2FWU.
6