Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
take
a seat
1. Plug it in
Plug the power cord into a grounded 120-volt power source.
2. Adjust the Recline Angle
Before adjusting the recline angle, be sure there is nothing located directly behind or beneath the chair.
Gently push down on the electric recline lever to recline, or pull up on the lever to adjust the angle forward.
Release the lever when you reach the desired angle. The chair automatically stops when you reach the
maximum recline or the full upright position.
NOTE: Lean back against the backrest before reclining the chair.
When adjusting the footrest up and down, you may notice a slight bumping sensation.
This is caused by the footrest locking mechanism, and is perfectly normal.
humantouch.com
10
Using your Human Touch Perfect Chair
seat and adjust the chair to the desired position. The Perfect
Chair cradles you in zero-gravity comfort, with your feet above
your heart—the ultimate neutral-posture position for back and
spine relief.
3. Adjust the Headrest
While seated, reach up with both hands and grasp both sides
of the headrest. You will feel the rigid frame beneath the soft
headrest pad. Grasping the rigid frame, tilt the headrest forward
or backward for maximum comfort. The headrest remains in this
position until you adjust it again.
4. Getting out of the Perfect Chair
While seated, pull up gently on the electric recline lever until the backrest automatically stops in a full
upright position and the footrest automatically stops in a vertical position (the backrest stops before the
footrest). Use the armrests for support when getting up from the chair.
CAUTION: Do not put any extra pressure on the footrest while returning the chair to an upright position.
Do not push on the footrest, or lean against it.
11
is easy. Just take a
Publicité
Table des Matières
