Table Des Matières - Sony XM-SD22X Instructions De Service

Table des Matières

Publicité

XM-SD22X
Note for Replacement of FET
Change the both channels of FETs at the output stage.
If one or both parts in the following combination is broken, the
service kit should be ordered.
Service kit part No.
Q108, 110, 112
X-3383-027-1
Q208, 210, 212
Q109, 111, 113
X-3383-028-1
Q209, 211, 213
Notes on Chip Component Replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES
SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT.
NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES
SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL
OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
2
TABLE OF CONTENTS
Location and Function of Controls .......................................... 3
Connections ............................................................................. 4
2-1. Bottom Plate ........................................................................ 7
2-2. Main Board Section ............................................................ 8
2-3. Main Board ......................................................................... 8
2-4. LED Board .......................................................................... 9
4-1. Block Diagram .................................................................. 11
4-2. Schematic Diagram -Main Section (1/2)- ........................ 12
4-3. Schematic Diagram -Main Section (2/2)- ........................ 13
4-4. Printed Wiring Boards -Main Section- ............................ 14
5-1. Heat Sink (Main) Section .................................................. 16
5-2. Main Board Section .......................................................... 17
.................................... 10
......................................... 18

Publicité

Table des Matières
loading

Table des Matières