HoMedics TWIN PERCUSSION PRO Mode D'emploi page 4

INSTRUCTIONS FOR USE
This appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
Fig. 1
1. Always make sure the unit is set to the "OFF" position before inserting the plug into a 120 volt
electrical outlet.
2. To turn the unit on, simply press the power button located on the top of the handle. This will start
the unit on the lowest setting. To increase the intensity of the massage, press the intensity control button
until the desired intensity is reached. To tum the unit off, press the power button.
3. To turn the heat function on, the massager must be on. To activate the Soothing heat function, press
the heat button located above the intensity button on the top of the handle. To cancel the Soothing heat
function, press the heat button a second time. NOTE: The Soothing heat function works best when the
red heat node attachments are used.
NOTE: Do not use the heat continuously for more than 15 minutes. Do not use the heat if you have
sensitive skin, poor circulation, discolored areas, swelling, burned, inflamed or where skin eruptions or
sores are present. Heat should be pleasant and comfortable. Should pain or discomfort result, discontinue
use and consult your physician.
4. Apply massager head lightly to the area you wish to massage.
5. Move the unit slowly, holding on the targeted area. Massage the area for a short period of time and
move to another area. Never massage the same spot longer than 3 minutes.
CAUTION: As stated in the "IMPORTANT SAFETY INSTRUCTIONS" section of this manual, never use this
appliance on or near eyes or other highly sensitive areas.
6. Operation of longer than 15 minutes is not recommended and may cause overheating.
4