Removing The Batteries; Set-Up Date And Time; Time Format; Measuring Blood Pressure - Lanaform ABPM-100 Mode D'emploi

Removing the batteries

• Flat and fully discharged batteries must be dis-
posed of in special containers or at collection
points intended for this purpose or returned
to an electrical appliance retailer. You have a
legal obligation to dispose of batteries properly.

SET-UP DATE AND TIME

• This menu allows you to adjust the following
functions one after the other:
Time Date Hour format
You must adjust the date and time.
Without these adjustments, it is impossible
to register and read your measurements
accurately with the date and time.

Time format

• Press and hold down the STOP/
START button and the memory
(2)
button at the same time for 3
(3)
seconds or insert the batteries.
• Using the memory button
format you require and confirm by pressing the
STOP/START button .
(2)
Date
• The year flashes on the screen. Using
the memory button , select the
(3)
year you require and confirm by
pressing the STOP/START button
• The month flashes on the screen. Using the
memory button , select the month you re-
(3)
quire and confirm by pressing the STOP/START
button .
(2)
• The day flashes on the screen. Using the memory
button , select the day you require and confirm
(3)
by pressing the STOP/START button
If the time format has been adjusted
to 12 pm, the order of the day and
month displayed is reversed.
Time
• The time flashes on the screen. Using the memory
button
firm by pressing the STOP/START button
• The minutes flash on the screen. Using the
memory button
require and confirm by pressing STOP/START
• Once all the dates have been adjusted, the device
automatically switches off.

MEASURING BLOOD PRESSURE

Positioning the cuff

• Put the cuff on your bare left
arm. The circulation in your
, select the time arm must not be restricted
(3)
by clothes that are too tight
or anything else.
• Position the cuff on your
arm so that the lower edge
is 1 - 2cm above the crook of your elbow and
above the artery. The pipe is directed towards
the middle of your palm.
• Now close the free part of the cuff around your
.
(2)
arm using the Velcro without making it too
tight. You must be able to insert two fingers
under the cuff.
• Now connect the cuff's pipe into the cuff's
power supply.
The device must only be used with the
original cuff. The cuff is intended for an
arm circumference of 22 to 30cm.
.
(2)
ABPM-100 EN Instruction manual
EN
FR NL DE SL SV
, select the time you require and con-
(3)
, select the minutes you
(3)
.
(2)
.
(2)
5
/ 74