Napoleon BILEX730 Mode D'emploi page 21

BILEX730 BUILT-IN INSTRUCTIONS
6 x N570-0073 (1/4-20 X 3/8")
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only, and must be installed and serviced
by a qualified installer to local codes.
1. Attach side mounting brackets to each side of the grill using #1/4-20 x 3/8" screws (N570-0073).
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be
applied to each wing of the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounting brackets.
Connect the flex supply line to the fitting at the end of the manifold.
4. The entire installation must be leak tested before operating the unit.
N415-0326 JAN 26.18
Install battery's as illustrated. Plug wire from LED (lights) located underneath
control panel into wire from battery pack. Ensure wires do not come in contact
with the bottom of the grill. The battery pack module must be mounted inside
the enclosure, at least 8 inches (20cm) below the bottom of the drippan, to
prevent the module from overheating. Ensure wires and module do not interfere
with drippan removal.
21
EN
3/8"(10mm)
www.napoleongrills.com