Cautions For Use - Pioneer XDP-30R Mode D'emploi

> Before Start > Part Names

Cautions for use

∫ If operation becomes unstable
0 The issue may be fixed by restarting this unit. Press and
hold the power button on this unit for 10 or more seconds
to restart the unit. (The settings in the unit are
maintained.)
∫ Removing the micro SD card
0 When removing the micro SD card, in the home screen
tap " " - "Unmount SD Card" - "SD Card 1" - or "SD
Card 2" to unmount the micro SD card, then remove it.
The card can be damaged or may stop working properly
if you fail to unmount the card first. Refer to (P5) for how
to remove.
∫ This unit
0 Use a 4-conductor plug for the Ø2.5 mm diameter
headphone jack of this unit, and use a 3-conductor plug
for the Ø3.5mm diameter headphone jack. It is not
compatible with microphone input.
0 This unit does not support simultaneous use of the
balanced headphone jack and the headphone jack.
Using both jacks at the same time may result in damage.
0 Take care that dust and foreign objects do not get into
the entrance of the micro SD card slot, as this can cause
a malfunction.
0 Do not press down with force on the unit when the unit is
placed with the screen facing down. This can damage
the LCD and the volume dial.
0 The antenna is built into the bottom of the back of the
main unit. The transmission speed of the unit may be
adversely affected if you block the antenna area with
your hand.
∫ Electronic authorization labeling
You can confirm information related to authorizations using
28
> Initial Setup > Playback
the following procedure:
1. Tap " " in the home screen.
2. Tap "Device Information".
3. Tap "Certification".
Advanced Setup | Supplementary Information | Others