Assembly Instructions - Powermate PWZC164000 Mode D'emploi

ASSEMBLY INSTRUCTIONS

• SAVE ALL INSTRUCTIONS
1. Locate and remove all loose parts from the carton. (Fig. 1)
2. Cut four corners of the carton from top and bottom and lay the panels fl at. (Fig. 2)
FIG. 1
3. Rotate the handle (A) up away from the pressure washer until it stops, pull out the
pin (B) and rotate the handle until it stops. Let go of the pin and move the handle
slightly to lock in place.
4. Roll the unit off the carton and discard carton.
5. Attach the nozzle panel (C) to the handle (A) with the 2 screws (D) provided as
shown in Fig. 3. Insert the 5 nozzle tips into the grommets on the panel.
6. Connect high-pressure hose to pump outlet (E). Tighten securely. (Fig. 3)
7. Connect wand to gun. Tighten securely. (Fig. 4)
8. Attach high-pressure hose to gun. Tighten securely. (Fig. 5)
NOTE: The pump on this unit is shipped with oil and a plug in the head that needs
to be switched with the dipstick before operating the pressure washer for the fi rst time.
9. Remove the plug (F) from the pump head and replace it with the dipstick supplied
with the pump. To check and change oil, refer to the "Maintenance" section of this
manual.
Copyright © 2011 MAT Industries, LLC
A
B
FIG. 2
E
6 - ENG
C
D
F
FIG. 3
FIG. 4
FIG. 5
200-2839