Ricoh 180 Manuel D'utilisation page 14

OVERVIEW
How to Connect to a Computer
Connect the machine to a computer using a parallel cable compliant with IEEE
P1284 (supplied by you).
Follow these steps to connect the machine to the computer:
A
Make sure you have the correct cable.
B
Make sure both the machine and the computer are turned off.
C
Attach the ferrite core provided with the PC INTERFACE KIT TYPE 180 to the
printer cable. The ferrite core should be attached to the cable close to the par-
allel port.
D
Plug the 36–pin end of the parallel cable into the parallel port on the left side
of the controller cover on the back of the machine.
E
Squeeze the wire clips on each side of the connector together until they snap
into place. The clips hold the cable securely in place.
F
Plug the end of the parallel cable into the computer's parallel port.
Note
The WinStyler T180 uses the bi-directional data transfer mode through the
LPT port of your PC. Consult your PC owner's manual to find out how to see
if the LPT port is set for bi-directional data transfers.
G
Turn on the machine and then the computer.
4