Omega Lift Equipment 60120 Manuel Des Consignes D'utilisation Et Des Pièces page 7

Assembly
Model 65123: (Refer to Figure 6)
Note: Do not tighten any bolts unless told to do so.
1. Attach base legs (1) and lower cross member ( 4) to upright channels (2) with bolts, lock washers and nuts (3).
Hand tighten only.
2. Attach support links (5) to the base (No.1) and upright channels (2) with bolts, lock washers and nuts (3).
3. Carefully slide bed frame (6) down to lowest possible position between the upright channels (2).
4. Slide head plate (7) to into upper cross members (8). Then, secure with bolts (9).
5. Attach the upper cross members assembly (8) to the upright channels (2) with bolts, flat washers, lock washers
and nuts (10).
6. Thread the ram (11) to head plate ( 7) on upper cross members (8).
7. Tighten all aplicable nuts and bolt assemblies.
8. Connect the male coupler end of hydraulic hose (12) to the female coupler of the ram (11) to complete the
connections.
9. Bring the bed frame (6) up and secure it with pins (13).
10. Place the Arbor Plates (14) on Bed Frame (6).
11. When necessary, replace the saddle of ram (11).with the bearing punch (15).
12. The press is now ready to use.
NOTICE: Before disassembly, carefully slide bed to its fully lowered position.
Model 65123
Size of Hardware Kits
3 bolt M10x30
lock washer M10
nut M10
9 bolt 10x30
10 bolt M16x120
flat washer M16
lock washer M16
nut M16
10
14
13
3
5
Qty
8
1
8
8
2
4
8
4
4
Figure 6 - Assembly Illustration for model 65123
15
2
6
4
7
11
8
7
12
9