Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SPECIFICATIONS (con't)
Model
Capacity
60123
12 Ton
60253
25 Ton
65123
12 Ton
Upper Cross Member
Bearing Punch
Pump Handle
Bed Frame
Support Pin
Arbor Plate
Support Link
Lower Cross Member
Figure 2 - 60123, 60253 & 65123 Shop Press Components (60253 shown)
PREPARATION
Before Use
1. Verify that the product and application are compatible, if in doubt call Omega technical service (888) 332-6419.
2. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product, its components and recognize the hazards associated with its use.
3. For Models 60120 & 60200: To familiarize yourself with basic operation of bottle jack, use the notched (or stamped)
end of provided handle to engage and turn the release valve:
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
extend the ram.
b. Counter-clockwise, but no more than 1 full turn from the closed position. This is the 'OPEN' release valve
position used to retract the ram.
For Models 60123, 60253 & 65123: To familiarize yourself with basic operation of hand pump, turn the release
valve:
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
extend the ram.
b. Counter-clockwise, but no more than 1 full turn from the closed position. This is the 'OPEN' release valve
position used to retract the ram.
4. For Models 60120 & 60200: With ram fully retracted and release valve closed, pump the operating handle. If the
ram responds immediately, press is ready for use. If ram does not respond, follow the Bleeding/Venting instructions.
For Models 60123, 60253 & 65123: With release valve opened, remove the oil filler screw. Ensure the oil level
is within 1/4" (6mm) of the opening. Reinstall the oil filler screw.
5. For Models 60120 & 60200: Check that the pump operates smoothly and that the extension screw will thread up/
down easily before putting into service. Replace worn or damaged parts and assemblies with Omega authorized
replacement parts only.
Dimensions
(W x D x H)
28" x 28" x 59"
21-1/4" x 16-1/8" x 31-1/2"
Min. Working
Max. Working
Space
Space
4-5/8"
36-3/8"
2-1/2"
34-1/4"
4"
17-5/8"
Ram
Hydraulic Couplers (1/4NPT)
Release Valve
*Hand Pump
Oil Filler Screw
Pump Bracket
Upright Channel
Base Leg
3
Bed
Position
8
4
Hydraulic Hose
(*) Air actuated hand
pump optional
Hydraulic
Stroke
6"
Publicité
Table des Matières
