Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
SAFETY and GENERAL INFORMATION
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
product before using. The owner and operator of this equipment shall have an understanding of this product and
safe operating procedures before attempting to use. The owner and operator shall be aware that use and repair of
this product may require special skills and knowledge. Instructions and safety information shall be conveyed in the
operator's native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of
this jack, remove from service immediately.
Inspect before each use. Do not use if broken, bent, cracked or damaged parts are noted. Any press that appears
damaged in any way, or operates abnormally shall be removed from service immediately. If any component of this
product has been subjected to a shock load (a load dropped suddenly, unexpectedly upon it), immediately discontinue
use until checked by a factory authorized service center (contact distributor or manufacturer for list of authorized
service centers). It is recommended that an annual inspection be done by qualified personnel. Labels and Operator's
Manuals are available from manufacturer.
PRODUCT DESCRIPTION
This Shop Press is designed for automotive, truck, implement, fleet, and industrial repair shops where pressing,
bending, straightening and forming, is required. Typical applications include installation and removal of alternator and
power steering pump bearings, axle bearings, transmission bearings, seals, u-joints and others. It is not intended
for use as an assembly table or as fixture stand used to secure a large, final assembly component. Unlike presses
equipped with a separately mounted pump, the power unit on this press can not be equipped with a pressure gauge,
therefore monitoring the load must be done by other means, such as a load cell w/ digital indicator. Whatever means
is chosen, the load measuring means shall be calibrated annually.
For Models 60123, 60253 and 65123:To reduce the risk of personal injury and/or property damage, ensure
!
that the rated working pressure of each pressurized attachment be equal to or greater than the rated working
pressure developed by the hydraulic pump.
SPECIFICATIONS
Model
Capacity
60120
12 Ton
60200
20 Ton
Upper Cross Member
Bottle Jack
Jack Bracket
Jack Handle
Bed Frame
Support Pin
Arbor Plate
Support Link
Lower Cross Member
Dimensions
(W x D x H)
22-3/4" x 18-1/2" x 59"
28" x 28" x 64-1/2"
Figure 1 - 60120 & 60200 Shop Press Components (60200 shown)
Min. Working
Max. Working
Space
Space
2-5/8"
34-3/8"
2-1/2"
34-1/8"
Oil Filler Plug
Handle Sleeve
Release Valve
Upright Channel
Base Leg
2
Bed
Hydraulic
Position
8
Saddle
Ram
Bottle Jack
Stroke
6"
Publicité
Table des Matières
