How To Read Connector Layout Diagram (Section 8A-3) - Suzuki SQ416 Mode D'emploi

8A-1-8 HOW TO USE THIS MANUAL
HOW TO READ CONNECTOR LAYOUT DIAGRAM
When necessary to know the location of an electrical part or an intermediate connector, it is easily possible to
retrieve it by this diagram.
First consult "SYSTEM CIRCUIT DIAGRAM" section or connector table at the right hand pages of this section for
the questioned connector code. Second refer to the diagrams of this section and look for the same code.
More information on use of the code is illustrated below.
Connector code
L 0 1
Connector No (serial No : 01)
Harness symbol (Refer to the table below)
Harness symbol and corresponding harness name
A : Battery cable
B : A/C harness
C : Engine harness
D : Injector harness
E : Main harness
E : Oil pressure switch wire
E : Console wire
G : Instrument panel harness
J : Front door wire
J : Rear door wire
J : Rear joint wire
K : Room light harness
K : Spot light wire
K : Roof wire
L : Floor harness
M : Rear bumper wire
O : Back door harness
O : License plate wire
O : High mounted stop light wire
Q : Air bag harness
Q : Pretensioner wire
R : Fuel pump wire
This indicates the ground point No.
The same No. is used as the ground point. (For the
details, refer to "GROUND POINT" section)
This indicates the connector code.
The connector code in the parentheses ( ) has the same
meaning as the above intermediate connector and at the
same time, it indicates that there is a harness continuity
between pages or illustrations in CONNECTOR LAYOUT
DIAGRAM section. That is, it suggests that the harness
}
is continued to the other page or illustration and the
continued harness can be identified by the same con-
nector code.