Shindaiwa BP530 Manuel D'utilisation page 19

1. Sleeve
2. Throttle cable
1. Black wire
1. Carburetor
2. Cable locknut
3. Connector
2. Red wire
3. Cable adjuster
3. Adjuster cover
Before you start
6. Put the throttle cable (flexible pipe side) through the cable
holder, and then connect the throttle cables in the connector
as shown.
7. Connect the red wire from the engine to the black wire from
the throttle, and connect the black wire from the engine to
the black wire from the throttle.
8. Clamp the connector and the wires with the enclosed cable
tie.
9. Test throttle control for smooth operation. If stiffness or bind-
ing are noted, the cause must be identified and corrected be-
fore the brushcutter can be placed in service.
10. Check the throttle control lever "free play" clearance. "Free
play" should be approximately 4-6 mm in the idle position. If
necessary, the "free play" clearance can be adjusted as
(1) Slide the adjuster cover forward to expose the cable ad-
juster.
(2) Loosen the cable lock nut.
(3) Thread or unthread the cable adjuster until the throttle
control lever has approximately 4-6 mm of "free play"
clearance.
(4) Tighten the cable lock nut.
(5) Slide the adjuster cover over the cable adjuster.
17