Lenze L-force 9400 Instructions De Montage page 53

(
Stop!
No device protection if the mains voltage is too high
The mains input is not internally fused.
Possible consequences:
ƒ
Protective measures:
ƒ
ƒ
(
Stop!
Filter may overheat
After a mains phase failure, the filter gets extremely hot.
Possible consequences:
ƒ
Protective measures:
ƒ
EDK94AZMP0494 DE/EN/FR 2.0
Destruction of the device if the mains voltage is too high.
Observe the maximally permissible mains voltage.
Fuse the device correctly on the supply side against mains
fluctuations and voltage peaks.
The filter might overheat and be destroyed.
Always connect the thermal contact of the filter and integrate it
such into the system monitoring that the mains supply will be
switched off (e.g. switch off the mains contactor control) when
the filter is overheated.
l
Electrical installation
Important notes
6
53