Installation Procedure - Toto TSMV Manuel D'installation Et D'utilisation

IMPORTANT: For proper installation and smooth operation, the valve must
be level and square to the finished wall.
• Install the valve so that the outside surface of the finished wall will be
between the Max and Min markings on the plaster guard.
• Make sure the valve is installed with the small arrow pointing in the
direction of water flow.
• Dashed pipework and fittings shown are not included.
• The plaster guard should remain in place until you are ready to install the trim.
• Do not attempt to remove the plug from the top port.
TSMVW
OUTLET 1
(SHOWERHEAD
RECOMMENDED)
OUTLET 2
MIXED WATER
INLET

INSTALLATION PROCEDURE

RIGHT PORT
PLUGGED
DO NOT REMOVE
ARROW MUST
POINT UP
2-1/2" [65mm] MIN.
3-3/4" [95mm] MAX.
4
TSMV
OUTLET 1
(SHOWERHEAD
RECOMMENDED)
MIXED WATER
INLET
.
.
FINISHED WALL
SURFACE
MIN./MAX.
MARKINGS
TOP PORT
PLUGGED
DO NOT REMOVE
OUTLET 2
ARROW MUST
POINT UP