Audiovox VME 9114 TS Instructions page 43

Switch to Radio Tuner source
• Touch the top left corner of the screen (the RADIO circle) to view the SOURCE MENU. Touch "Radio".
Select FM/AM Band
Touch the BAND button (11) on the screen, or press the BAND button on the unit (5) to change between the following bands: FM1, FM2, FM3, AM1,
and AM2
NOTE: The BAND button on the unit only works when the TFT is closed.
Seek Tuning
To seek the next higher station:
• Touch the >>| button on screen.
To seek the next lower station:
• Touch the |<<| button on screen.
Manual Tuning
To increase or decrease the tuning frequency one step:
v
^ ^
• Touch the or v buttons on screen.
Direct Tuning
To enter a radio station directly, touch the
Using Preset Stations
Six numbered preset buttons store and recall stations for each band. All six stored
stations (P1-P6) for the current band appear on the screen.
Storing a Station
1. Select a band (if needed), then select a station.
2. Touch the on-screen MEM button (18) to open the preset screen.
3. Touch the preset number in which you would like to store the current station (or press
EXIT to cancel and closethe menu). The preset number and station appears highlighted.
Recalling broadcaster using the presets and the Automatic Storing ( AS) Function:
Recalling a preset station
1. Select a band (if needed), then select a station.
2. Touch the on-screen preset button (P1-P6) to open the preset screen.
3. Touch the preset number in which you would like to store the current station (or press EXIT to cancel and close the menu). The preset number and
station appears highlighted.
button.
Enter the desired radio station using the on-screen numberpad. Press the enter button (arrow) to tune to
the selected station. To exit the screen without changing the station, touch Exit. To clear your entry and start over,
touch Clear.
16