Audiovox VME 9114 TS Instructions page 41

Hardware Sub-menu Features
Setting Options
Camera In Normal
Mirror
TFT Auto Open On
Off
Manual
Video Input (Input NTSC
circuitry autode-
tects the video PAL
signal from the
Aux In source). AUTO
Optionen des Untermenüs P. Vol
Setting Options
Source Radio
Disc
USB
AUX
TS Cal (Screen Calibration)
To access the "Screen Calibration" function from the SETUP menu, select the "TS CAL" option.
After entering calibration mode, a crosshair appears in a corner quadrant of the screen. To begin calibration, press and hold the crosshair for one se-
cond until it moves to the next quadrant. Continue for each quadrant until the calibration is completed.
Demo Sub-Menu Features
You can stop/run demonstration mode or turn Demo Auto Run on/off by choosing the "Demo" option from the SETUP MENU.When Demo
"Auto Run" is Off, you can select "Demo > Run" to start Demo Mode. Demo scrolls through the various source screens, simulating ac-
tivity on the display. "Demo" is discreetly displayed in blue text (below the clock), to indicate the unit is in Demo Mode. To stop Demo
Mode, touch the upper-left quadrant of the TFT (Source select).When Demo "Auto Run" is On, the unit will automatically display Demo
Mode when powered on.
Function
Images, the camera around as you would look in a mirror.
The TFT panel automatically opens when the unit is turned on.
You must press the OPEN button (1) to open the TFT panel.
When the ignition is turned OFF, the TFT panel DOES NOT retract if it was previously out.
The color signals are output in the standard NTSC format.
The color signals are output in the standard PAL format.
The color signal output is switched automatically based on the current video input signal - NTSC or PAL.
Function
Choose a sourcefor which you would like to increase the relative volume (LEVEL).
Use the +/- buttons to increase relative volume for specified source up to 6 decibels.
14