emerio BestMatic SBS-125596.1 Mode D'emploi page 9

by the refrigerator or other objects. Before switching on the refrigerator, please check the voltage range of
refrigerator carefully if the same as that of the power supply.
When the refrigerator is first installed, allow it stabilize at normal operating temperatures for 2-3 hours prior to
filling it with fresh or frozen foods.
If operation is interrupted, wait for 5 minutes before restarting.
DISPLAY CONTROLS
Use your appliance according to the following control regulations, your appliance has the corresponding
functions and modes as the control panels showed in the pictures below. When the appliance is powered on for
the first time, the backlight of the icons on display panel starts working. If no buttons have been pressed and
the doors are closed, the backlighting will turn off.
1. Mode button
2. Freezer compartment temperature control button
3. Fridge compartment temperature control button
4. Lock icon
5. Temperature indicator lights for freezer compartment
6. Temperature indicator lights for fridge compartment
7. Super cool mode indicator light
8. Super freeze mode indicator light
9. Intelligence mode indicator light
Controlling the temperature
The default temperature for the refrigerator is set to "•" (4°C) and the freezer to "•" (-18°C). If you want to
change the temperature, follow the instructions below.
Caution! When you set a temperature, you set an average temperature for the whole refrigerator cabinet.
Temperatures inside each compartment may vary from the temperature values displayed on the panel,
depending on how much food you store and where you place them. Ambient temperature may also affect the
actual temperature inside the appliance.
Note: the temperature will impact the storage time of food. Set the temperature as necessary. Warmer will
accelerate food spoilage and colder will froze food bad. Thus, food to be wasted.
1. Lock/unlock
Press "Mode" for 3 sec., icon " " will be off and the panel is unlocked.
Without any operation in 20 sec., the panel will be locked automatically and whole light will be off after about
60 sec..
2. Fridge
Press "Mode" for 3 sec. to unlock the panel. Press "Fridge" to set fridge temperature between 2°C and 7°C as
needed, and control panel will display corresponding values according to the following sequence with the light
on.
After 3 sec., the light goes off and the temperature is set. It's suggested to set "•" (4°C) for daily use.
3. Freezer
- 8 -