emerio BestMatic SBS-125596.1 Mode D'emploi page 14

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Interior cleaning
You should clean the appliance interior regularly. It will be easier to clean when food stocks are low. Wipe the
inside of the fridge freezer with a weak solution of bicarbonate of soda, and then rinse with warm water using
a wrung-out sponge or cloth. Wipe completely dry before replacing the shelves and baskets. Thoroughly dry all
surfaces and removable parts.
Although this appliance automatically defrosts, a layer of frost may occur on the freezer compartment's interior
walls if the freezer door is opened frequently or kept open too long. If the frost is too thick, choose a time when
the supply of food stocks is low and proceed as follows:
1. Remove all food and accessories baskets, unplug the appliance from the mains power and leave the doors
open. Ventilate the room thoroughly to accelerate the thawing process.
2. When defrosting is completed, clean your freezer as described above.
Caution!
Don't use sharp objects to remove frost from the freezer. Only after the interior completely dry should the
appliance be switched back on and plugged back into the mains socket.
Door seals cleaning
Take care to keep door seals clean. Sticky food and drinks can cause seals to stick to the cabinet and tear when
you open the door. Wash the seal with a mild detergent and warm water. Rinse and dry it thoroughly after
cleaning.
Caution! Only after the door seals are completely dry should the appliance be powered on.
Replacing the LED light
Warning: the LED light must not be replaced by the user! If the LED light is damaged, contact an authorized
service representative for repairing.
WATER DISPENSER
The refrigerator is built with a water dispenser.
The water dispenser allows access to chilled water without having to open the refrigerator door.
The number of door openings is thus reduced, less cold air is lost from the refrigerator and you save on electricity
costs.
Filling the water tank
Open the cap of the water tank filling nozzle.
Fill with pure and clean drinking water.
Do not overfill the tank. The capacity is 2L.
Close the cap.
Notes: Do not fill water tank with any liquid other than drinking water. Beverages such as fruit juice, carbonated
fizzy soda drinks and alcohol are not suitable for use with the water dispenser. If such liquids are used, the water
dispenser may malfunction and be damaged beyond repair. Some chemical ingredients and drink additives may
also attack and damage the water tank material. The guarantee does not cover such eventualities.
Using the dispenser
Push in the lever of the water dispenser with your glass.
Releasing the lever, stops further dispensing of water.
- 13 -

Publicité

Table des Matières
loading

Table des Matières