emerio BestMatic SBS-125596.1 Mode D'emploi page 8

SBS-125596.1
STRUCTURE ILLUSTRATION
A: Freezer compartment
1. Freezer LED light
2. Freezer door rack
3. Freezer glass shelves
4. Freezer drawer cover
5. Freezer drawer
Note: The glass shelves and the crisper can be removed and inserted for cleaning and storing of food according
to the appliance.
TRANSPORT AND HANDING
When transportation, hold the base and lift the refrigerator carefully with an angle inferior at 45 degree.
Never hold the door handle as support. Never place it upside down nor horizontally. Push refrigerator on its
basis and place it thanks to its roller feet.
INSTALLATION
This refrigerating appliance is not intended to be used as a built-in appliance.
To fix stably, the appliance must be placed on a flat and solid surface. It should not be laid on any soft material.
Choose a location where there is no heat source. Keep the refrigerator away from direct sunlight or other
appliance producing heat.
Choose a dry and well-ventilated place where there is no corrosive air.
In order to improve efficiency of the cooling system and save energy, it is necessary to maintain good ventilation
around the appliance for the dissipation of heat. For this reason, sufficient clear space should be available around
the refrigerator.
Place the appliance against a wall with a free distance that not exceeding 75mm but more than 50mm.
FIRST USE
Before the use of the refrigerator, remove all the packages, including bottom cushion and foam pads and rubber
belts in the refrigerator.
Adjust the feet and clear the outside and inside of the refrigerator with warm cloth.
Do not start the refrigerator immediately after vertical placement. Only start it after 2-6 hours standing to ensure
its proper operation.
To prevent damage to the power cord and any consequence incidents, the power cord should be not covered
B: Fridge compartment
6. Fridge LED light
7. Fridge door rack
8. Water filling nozzle
9. water tank and tank cover
10. fridge glass shelves
11. Fridge crisper cover
12. Fridge crisper
- 7 -
13. Control panel
14. Water dispenser
EN