Preparation; Preparing For Startup - Kobalt 3332643 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

SAFETY INFORMATION
Risk to breathing. Read all labels when you are spraying paints or toxic materials, and follow
the safety instructions. Use a respirator mask if there is a chance of inhaling anything you are
spraying. Never directly inhale the compressed air produced by a compressor.
Risk of eye injury. Always wear ANSI 287.1 approved safety goggles when using an air
compressor. Never point the nozzle or sprayer toward a person or any part of the body.
If the spray penetrates the skin, serious injury may occur.
Never exceed the maximum working pressure of the tool.
Never attempt to open the drain valve when the tank pressure is more than 10 PSI.
You can create dust when you cut, sand, drill or grind materials such as wood, paint,
metal, concrete, cement, or other masonry. This dust often contains chemicals known
to cause cancer, birth defects, or other reproductive harm. Wear protective gear.
CAUTION
Pull the pressure relief valve ring daily to ensure the valve is functioning properly.
The unit must be kept a minimum of 12 in. from the nearest wall, in a well-ventilated area
for cooling.
Protect the air hose and electric cord from damage and puncture. Inspect them weekly for
weak or worn spots.
Always wear hearing protection when using an air compressor. Failure to do so may result
in hearing loss.
Operation of the unit should always be in a position that is stable. Never use the unit on
a rooftop or elevated position that could allow the unit to fall or be tipped over.

PREPARATION

Preparing for Startup

WARNING: Risk of bursting. Too much air
pressure causes a hazardous risk of bursting.
Check the manufacturer's maximum pressure
rating for air tools and accessories. The regulator
outlet pressure must never exceed the maximum
pressure rating.
a. Set the ON/OFF switch (I) to the off position.
b. Turn the air pressure regulator knob (D)
counterclockwise until it stops.
c. Attach air hose/accessories or air tools
(not included) to the quick coupler (F).
6
D
I
OFF
ON
F

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

0905518

Table des Matières