Part Description - Kobalt 3332643 Mode D'emploi

PARTS DESCRIPTION
PART PART NAME
A Electric Motor
Air Compressor Pump
B Air Tank
C Tank Pressure Gauge
D Air Pressure Regulator
E Regulated Pressure Gauge
F Quick Coupler
G Air Tank Drain Valve
H Pressure Relief Valve
I ON/OFF Switch
J
Power Cord

PART DESCRIPTION

The motor is used to power the pump. It contains a thermal
overload protector. If the motor overheats for any reason,
the thermal overload protector will shut it down in order to
prevent the motor from being damaged.
The pump is used to compress the air and discharge it into
the tank via the piston moving up and down in the cylinder.
The tank is used to store the compressed air.
The gauge is used to measure the stored air pressure level of
the tank. It is not adjustable by the operator and does not
indicate line pressure.
The regulator is used to adjust line pressure to the tool you are
using. Turn the knob clockwise to increase pressure and
counterclockwise to decrease pressure.
The gauge is used to measure the regulated outlet pressure.
For this compressor, the quick coupler is also used as
the air line outlet. The outlet is used to connect the 1/4
in. air hose.
The drain valve is used to remove moisture from the air tank
after the unit is shut off.
T he valve is used to prevent system failures by relieving
pressure from the system. If the pressure reaches the preset
level and the pressure switch will not shut down the motor, it
will automatically pop open. You can also pull the ring on the
valve to open.
Your air compressor operates by the use of a pressure switch.
Always make sure the lever is in the "OFF" position before
plugging in the power cord. By moving the lever to the "Auto"
position, the compressor will start and stop auto matically
within the setting of the pressure switch which are typically
120 - 150 PSI. Do not attempt to stop the compressor by
unplugging the power cord. To stop, simply move the lever
to the "Off" position.
This product is for use on a nominal 120-volt circuit and
should be grounded. A cord with a grounding plug as
illustrated must be used. Make sure that the product is
connected to an outlet that has the same configuration as
the plug. No adapter should be used with this product.
Grounded
outlet
Plug
Grounding Pin
4