Pride TRAVEL SCOOTER Serie Manuel Du Propriétaire page 12

I I . Y O U R T R A V E L S C O O T E R
1
Figure 10. Securement Points (Identified with black dots)
SHROUD PANELS
On certain models, you can change the color of your
Travel Scooter by removing the colored plastic
shroud panel pieces and replacing them with one of
the other supplied sets. The panels are held in place
by a hook and loop reusable fastener. See Travel
Scooter Features Table (inside front cover).
To remove the shroud panel pieces:
1. Use your finger to locate the push hole behind
each shroud piece.
2. Push through the hole to separate the piece
from the Travel Scooter. See figure 11.
To remove the tiller console visor:
1. Gently pull the top of the visor away from the
tiller console, then slowly lift it up and away
from the tiller console. See figure 12.
To reinstall the shroud pieces, place each piece in its
appropriate location and push with slight pressure to
secure the reusable fastener.
NOTE: When installing the front and rear fender
panels, make sure the tab at the bottom of each
panel is inserted into the tab opening before
securing the panel. See figure 11.
12
IDENTIFICATION KEY
1. Front Securement Points (3-wheel models)
1a. Models 83 and 84 only
1b. Models 36, 40X, 44X, 40E, 44E, 40LX, 44LX, 50LX, 54LX, 53, 53HD, 54, 54HD, 73, and 74
2. Front Securement Points (4-wheel models)
3. Rear Securement Points
2
1a
1b
3
IDENTIFICATION KEY
1. Rear Fender Panel
2. Front Fender Panel
1
2
1
Figure 11. Fender Panels
Figure 12. Tiller Console Visor
2
2
1
2
1
Travel Scooter Series