emerio FH-124273.1 Mode D'emploi page 8

(3) There may be a trace of odour during the first few minutes of initial use, or after a period of storage. This
is noraml and will quickly disappear.
1. Power setting
Press the "Mode" button to select your desired power setting: Fan (
corresponding indicator light will be on.
2. Temperature setting
Press the button "-" or "+" on the remote control or "Tem." on the control panel to set the desired
temperature. You can choose from 15℃ to 40℃. When you set your desired temperature, it will flash a few
seconds, and then shows the room temperature again.
When the set temperature is 4℃ or more higher than the room temperature, the appliance will work on high
heat;
When the set temperature is 2-3℃ higher than the room temperature, the appliance will work on low heat;
When the room temperature reaches the set temperature, the appliance will switch to fan mode automatically.
Note:
(1) The power setting and temerperature seting cannot coexist; the appliance will run according to the the
lastest setting.
(2) During use, if there is no operation within five minutes, the display and indicator lights will be off. Press
any button to activate the product.
3. Time setting
Press the button "Timer" to set your desired working time from 00 (off) → 01 (1h) → 02 (2h) → ... → 12 (12h)
→ 00 (off) → .... The timer icon will be on. When the set time has elapsed, the appliance will be off and under
standby condition.
4. Oscillation
Press the button "Swing", the appliance begins to swing in horizontal direction. The swing icon will be on. Press
the button again, the oscillation will stop.
5. Turn off
Press the button "On/off" again to turn off the appliance. Cold air will continue to below out for another 30
seconds to protect and enhance the lifespan of the product. Turn off the main power switch and unplug the
power cord from the outlet.
SAFETY SYSTEM
The appliance comprises a protection device protecting against overheating. A temperature limiting
⚫
system inside the appliance will automatically cut the power supply from the heating element while the
ventilator continues to function to cool the appliance. The appliance can re-start as soon as the normal
conditions and temperature needed for it to function are re-established. Identify the causes of this
overheating to avoid any recurrences
This heater is equipped with a tilt protection safety device. For safety reasons, the unit will automatically
⚫
switch off the power if it is put on unstable or uneven surfaces or if it is tilted accidentally.
CLEANING AND MAINTENANCE
Before maintaining, please unplug the appliance and make sure the heater has cooled down completely.
⚫
); Low heat (
- 7 -
); High heat ( ). The