Getting Started - Leckey Transat de bain Guide De L'utilisateur

Getting Started

1.0
1.1
1.2
2.0
2.1
2.1
a 2.2
2.2
How to Unpack and Assemble
Congratulations on purchasing your Leckey Bath Chair. Your
Bath Chair will come bubble wrapped, flat packed and
without the cover attached. To attach the cover, position
the bath seat with the calf support in the maximum position
as shown, then firstly slip the cover over the backrest and
then secondly the calf support. Then loop the straps in
through the frame securing the fabric under the seat base
as shown in 1.2.
Your Leckey Bath Chair will come with a hip belt already
attached and chest belt with lateral supports. Additional
straps as ordered will also be included.
PLEASE CHECK THAT YOU HAVE ALL THE PARTS YOU
ORDERED.
How to Adjust
Height Adjustment
The Leckey Bath Chair can be adjusted in height to allow
for a range of positions from flat in the bath to over bath
height. The height is adjusted by pulling down on both sets
of levers (a) and adjusting the front and back legs to the
required position. Once the required position is obtained
simply release the levers (a). For stability reasons we do
not recommend that both sets of legs be adjusted to their
highest position at the same time.
Tilt in Space
The independent height adjustability of the Leckey Bath
Chair front and back legs allows the seat to be adjusted for
a range of tilt in space positions. These adjustments are
carried out in the exact same way as the height adjustment
described above.