Lenz Digital plus LE1035A Manuel page 23

3 Installation of the LE1035A
Take note of which motor connection is linked to the right-hand locomotive wheels and which to the
left. If you do this you will not have to try out which cable of the decoder needs to be soldered to
which connection of the motor in order to achieve the desired direction of travel.
After the removal of the original connections to the motor brushes, both the motor brushes must be
potential free and completely isolated from both tracks. This means that they must not be
connected in any way to the chassis or to the wheels of the locomotive. Also bear in mind that such
connections are sometimes created only when the chassis is put back!
Please contact a service centre if you are in any doubt as to whether all preconditions for the
installation are fulfilled!
First connect the decoder to the pick-ups from the wheels of the locomotive:
•
red cable to the wheels which in relation to the direction of travel are on the right-hand side of
the locomotive
•
black cable to the wheels which in relation to the direction of travel are on the left-hand side
of the locomotive
Then connect the decoder to the motor connections:
•
orange cable to the motor connection previously connected to the right-hand locomotive
wheels
•
grey cable to the motor connection previously connected to the left-hand locomotive wheels.
Now connect the functions. Ex-works default settings for the functions are configured as follows:
function outputs A and B as direction-dependent outputs reacting to F0. This configuration can be
altered as desired.
23
E