Resetting The Decoder - Lenz Digital plus LE1035A Manuel

31
7 Programming the decoder.
The locomotive address, acceleration and deceleration delay, and all other features of the
E
locomotive decoder can be changed as often as desired by reprogramming. The features are
"stored" permanently in special locations even when the operational voltage is switched off. These
locations are called "configuration variables" or simply CV. The configuration of the values is done
electronically, which means that it is not necessary to open the locomotive again after the decoder
has been installed.
To program the locomotive decoder you need one of the following Digital plus systems:
LZ100 / LZV100 (with manual controls or the interface); SET02; compact. For detailed instructions
on how to program using the devices mentioned, please refer to the operating instructions which
accompany those devices.
On delivery the decoder is programmed for operating with address 3, 28 running notches. The
decoder can be used immediately on purchase with these basic configurations. All configurations
can, of course, be changed.

7.1 Resetting the decoder

If you wish to reset all the decoder CVs to the ex-works setting, enter 33 in CV8.