Error Messages - Honeywell Home Resideo EW701 Instructions De Service Et De Montage

Error messages

Error display
Error messages with module in place
Error display
Fault messages with the ultrasonic measurement system
Error display
V1.00 / 3.5.2018
Error description
• Hardware error or
damaged firmware
• Supply flow sensor
broken
• Supply flow sensor
short-circuit
• Return flow sensor
broken
• Return flow sensor
short-circuit
Error description
• Add-on module has
been paired with
another metering
device before
• The module has the
measuring data of
another meter
• Low power
(radio add-on module)
• Radio add-on module
not initialised (clock
wrong)
Error description
• Air in the measure-
ment section
• No correct ultrasonic
measurement signal
MU2H-0501ge23 R1020
Measures/notes
• Check flow sensor, connection
cable and calculator unit for external
damage
• Device must be replaced
• Check temperature sensor and pipes
for mechanical damage
• Device must be replaced
• Check temperature sensor and pipes
for mechanical damage
• Device must be replaced
• Check temperature sensor and pipes
for mechanical damage
• Device must be replaced
• Check temperature sensor and pipes
for mechanical damage
• Device must be replaced
Measures/notes
• Save data, since these are overwrit-
ten after a short time
• Press any key to delete the display
• After deletion the new add-on mod-
ule will be accepted
• Maximum operating duration expired
• Add-on module must be replaced
• Add-on module must be replaced
Measures/notes
• Vent pipework
59 EN