Ingenico PP30s Notice D'installation page 2

page de 2

/ 2
Signets

Les langues disponibles

Safety instructions : Lithium battery :

PP30S equipment is equipped with a lithium battery which is non‐accessible for the user. Only a qualified operator is

authorized to open the unit and to replace this component.

Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions.

VORSICHT: PP30S ist mit einer Lithium‐Batterie, die nicht zugänglich ist für den Benutzer ausgestattet. Der Wiedereinbau

der Batterien muß von qualifiziertem Personal bewirkt werden

Beachten Sie die Polarität für die Batterie Lithium. Eine fehlerhafte Installation der Batterie kann eine Explosion führen .

Entsorgen Sie die Batterien entsprechend den Anweisungen des Herstellers

CAUTION : For Switzerland, Annex 4.10 of SR 814.013 applies for batteries

Keypad functions

FCC ID : XKB‐PP30S ‐ available on the followings equipments:

PP30S‐110‐01 : 296101195

This equipment as been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interface in a residential

installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in

accordance with instruction, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception which can be determined by turning the equipment off and on the

user is encouraged to try to correct interface by one more of the following measures :

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and receiver.

•

Connect the equipment into a outlet on circuit different from that to which the receiver is

connected.

•

Consult the dealer or an experience radio/TV technician for help.

CAUTION : The user is cautioned that any changes or modification not approved by INGENICO could void user's authority to operate

the equipment.

End‐of‐life

The product belongs to the family of electrical and electronic equipment. Therefore, it is subjected to the WEEE directive which requires the collection

and the recycling at the end of life product. The Ingenico products present the symbol for the marking of electrical and electronic equipment as

required by the WEEE Directive. The crossed‐out wheeled bin printed on the product gives the information about the requirement not to dispose of

WEEE as unsorted municipal waste and to collect such WEEE separately. To assure that the product is collected and recycled with respect to the

environment, you must contact your supplier (in defect, contact the Ingenico local office or the commercial head office in charge of your country on

www.ingenico.com, « contact us » page). The abandonment or uncontrolled disposal of waste can cause harm to environment and to human health.

So, by recycling your product in a responsible manner, you contribute to the preservation of natural resources and to the protection of human health.

Security of your terminal

Upon receipt of your terminal you should check for signs of tampering of the equipment. It is strongly advised that these checks are performed

regularly after receipt. You should check, for example: that the keypad is firmly in place; that there is no evidence of unusual wires that have been

connected to any ports on your terminal or associated equipment, the chip card reader, or any other part of your terminal. Such checks would provide

warning of any unauthorised modifications to your terminal, and other suspicious behaviour of individuals that have access to your terminal. Your

terminal detects any "tampered state". In this state the terminal will repeatedly flash the message" Alert Irruption!" and further use of the terminal will

not be possible. If you observe the "Alert Irruption!" message, you should contact the terminal helpdesk immediately. You are strongly advised to

ensure that privileged access to your terminal is only granted to staff that have been independently verified as being trustworthy.

ask the customer to divulge their PIN Code. Customers should be advised to ensure that they are not being overlooked when entering their Pin Code.

296103991

INGENICO – 192 avenue Charles de Gaulle – 92200 Neuilly sur Seine ‐ FRANCE

Tél. 33(0)1 46 25 82 00 ‐ Fax 33 (0)1 47 72 56 95

www.ingenico.com

PP30s installation manual

UP Arrow keypad

Physical characteristics : Weight (without cable)

DOWN Arrow keypad

Operating conditions : Temperature