Zephyr Essentials Pyramid ZPY-E30AB Guide D'utilisation, D'entretien Et D'installation page 15

Hood is designed for installation under a
kitchen cabinet
1. Select preferred duct location (vertical or
horizontal) if ducting out of kitchen. Refer to
page 10 for details.
2. Install utensil bar to hood. Refer to page 12 for
details.
3. Begin installation by removing the mesh fi lters
and light panels (Fig 4).
4. Reinforce cabinet with 1"x2" wood strips
if additional strengthening is required or if
cabinets are framed.
5. Temporarily position the range hood in the
desired mounting location. Measure and
mark the mounting holes, duct and electrical
locations with a pencil.
6. Drill/cut out the required openings for duct and
electrical access; make sure the duct opening
is large enough to apply duct tape.
7. Fasten hood onto cabinet with (4) M4 wood
screws provided.
8. Install electrical.
9. Install duct work and seal with duct tape.
10. Reinstall mesh fi lters and light panels.
11. Power up hood and check for leaks around
duct tape.
12. If recirculating the hood refer to page 11 for
more details.
Push in on panel latch then pull panel down
Fig 4
13
8. Electrical
6. Duct
opening/
cutout
9. Aluminum duc
tape
4. Add 1"x2"
wood strips
2. Mesh
filters
Fig 3